1、按通则部分规定执行启动前对济南壁挂炉http://www.jnccnt.cn/进行检查,确认济南壁挂炉送风机电源已送上,确认济南壁挂炉油系统电源已送上。
Before performing according to General section provides start to Jinan boiler check to make sure the blower is powered boiler Jinan sent, confirmed Jinan oil boiler system is powered send.
2、联系济南壁挂炉热工人员动叶调整装置送电,启动油泵,并将备用油泵投入联动,济南壁挂炉所有未运行吸、送风机的出口挡板开启,入口动叶全开。
Contact Jinan boiler thermal personnel bucket adjustment device transmission, start the pump and spare pump into linkage, Jinan boiler is not running all the suction blower outlet damper opening, entrance bucket full.
3、济南壁挂炉风机启动条件满足:油箱油温正常(高于63℃或低于32℃均报警);油箱油位>1/2;润滑油油>0.172MPa;动叶关闭;各轴承温度<80℃;对应侧引风机运行且动叶控制在自动;另一台送风机启动命令未出现。
Jinan boiler fan start conditions are met: Fuel oil normal (above 63 ℃ or below 32 ℃ are the police); fuel tank level> 1/2; lubricating oil pressure> 0.172MPa; buckets closed; each bearing temperature <80 ℃; the corresponding side of
the suction fan running and the rotor blades in the automatic control; another blower start command does not appear.
4、关闭济南壁挂炉http://www.jnccnt.cn/送风机出口挡板,启动送风机,开启送风机出口挡板,调节动叶开度使锅炉风量≥30%MCR。
Close Jinan boiler blower outlet damper, start the blower, blower outlet damper open, adjust the movable vane opening the boiler air volume ≥30% MCR.
推荐壁挂炉知识
- 佑玛壁挂炉温控器有哪些作用?
- 济南壁挂炉过热怎么办?
- 燃气壁挂炉要定期除垢清洗
- 济南壁挂炉装置办法解析
- 定期对济南壁挂炉进行清洗保养有哪些好处?
- 六个做法轻松破解山东壁挂炉耗气
- 济南壁挂炉如何做好防冻措施?
- 影响济南燃气壁挂炉供暖效果的几个因素
- 济南壁挂炉内部如何正确清洗?
- 济南壁挂炉夏季不用时需要通电吗?
- 电蒸汽锅炉的安全阀工作原理介绍
- 济南壁挂炉安装管路系统有哪些要求呢?
- 济南壁挂炉内部如何清理?
- 济南壁挂炉安装要求
- 济南壁挂炉厂家告诉您温控器的三大优点
- 壁挂炉价格的主要影响因素
- 山东燃气壁挂炉安装维修小知识
- 山东燃气壁挂炉采暖暖气片为什么会上热下冷?
- 佑玛壁挂炉电采暖系统如何进行调试?
- 济南壁挂炉该清洗的几个信号