返回首页| +15253134653
    壁挂炉产品推荐
新闻动态当前位置:首页-济南壁挂炉温控器安装有哪些步骤?
济南壁挂炉温控器安装有哪些步骤?
2014-10-18 14:42:18

通常壁挂炉采暖用户在安装时都会要求配置一个温控器,温控器上的热敏元件,电阻随温度而变化,当电阻变化到某一标定值的时候,继电器即能进行开关动作,同时控制壁挂炉的启停,主要是为了后期使用过程中节约能源,那么壁挂炉温控器如何安装?

1、稳定温控器安装位置。
可以在装修时先布好线,使用后感觉需要时再装,位置要专业人员来帮助确定,因为温控器内有温度感应装置,所以要避开大门,暖气等的平均温度区,和经常活动区域以便调节方便。要安装在易操作的地方,能涵盖平均温度的地方,人活动较多的地方及能避开冷源、热源、风道的地方。
You can be a good line in the decoration cloth after use feeling and then loaded when needed, to help determine the position to be professional, because there are temperature-sensing device inside the thermostat, so to avoid the doors, heating, etc. The average temperature zones, and often activity area for easy adjustment. To install and easy to operate in place, to cover the average temperature of the place, where human activities and more able to avoid the cold, heat, wind tunnel places.
2、壁挂炉温控电源线预留
确定好温控器安装位置后,应在当前位置向下开一条小槽,将线沿墙跟摆放,一直沿墙直到壁挂炉下边,在墙上槽内的线要用小线卡钉紧,之后将槽涂平,壁挂炉温控器电源线最好是在锅炉安装前预留好。
Determine a good thermostat installation location, it should be opened at the current location down a small groove, with the wire placed along the wall, along the wall until the boiler has been lower in the wall slot line cards use a small wire nails tight after the tank painted flat, boiler thermostat power cord is best to reserve well in front of the boiler installation.
3、壁挂炉温控器接线注意事项
在壁挂炉底部,任意选定接线口,穿线用2×0.75及以上线径的多股双绞软线,穿线室内预留0.5米,壁挂炉预留1米,将预留线绕成团放入盒内,再用相同大小的硬泡沫封死线盒。
In the bottom of the boiler, arbitrarily selected wiring mouth, threading with 2 × 0.75 and above diameter multi-strand twisted cord, threading indoor aside 0.5 meters, boiler set aside one meter, will be wound into the group put aside into the box, then the same size hard foam sealed box.

济南壁挂炉http://www.jnccnt.cn/

此站带排名出售
联系手机:15253134653
联系QQ号:347299818
联系微信:扫描下图二维码