返回首页| +18854175316 / 15253134653
    壁挂炉产品推荐
新闻动态当前位置:首页-济南壁挂炉装置办法解析
济南壁挂炉装置办法解析
2017-1-3 10:02:24

1.装置济南壁挂炉之前,先确认壁挂炉的装置位置及用燃气能否分歧的,假如不分歧应互换。假如没有预留烟道及挂炉子的小孔,则先要先打烟道口,并预留足够管路直径。假如装置位置是不耐热的墙壁,应采用隔热维护安装。Before the unit of Ji'nan boiler bigualu, make sure the position of the device and whether differences in gas, if no differences should swap. If you do not reserve the flue and hang the stove holes, we must first hit the flue, and reserve enough pipe diameter. If the device is not heat resistant wall, should be used to protect the installation of insulation.

2.装置模板与挂钩。在购置济南壁挂炉机箱中会附带装置模板支架,先在墙上钻孔,用固定螺栓将其固定到墙上,留意两侧间隙至少预留10毫米。再在模板固定装置提供的螺栓和挂钩。然后,装置燃气阀,在系统最高点装置排气阀,在最低点装置充注阀和排水阀。Device template and hook. In the purchase of Ji'nan bigualu chassis will be attached to the template support device, to drill holes in the wall will be fixed to the wall with a fixed bolt, pay attention to reserve at least 10 mm on both sides of the gap. Bolt and hook provided in the template fixing device. Then, the gas valve, the system at the highest point of the exhaust valve, at the lowest point of the filling valve and drain valve.

3.装置济南壁挂炉。取出济南壁挂炉本体,先取下旋钮,卸下外壳,将设备装置到墙壁挂钩上。然后开端装置烟道,衔接下部的五根管道,留意要加上垫片,拧紧。最后接上电源和室内温度控制器。翻开机器前面板,依照N、L、E接好电源,依照温度控制器请求衔接1-3触点,再装上外壳。Ji'nan boiler device. Remove the Ji'nan boiler body, remove the knob, remove the shell, the device to the wall on the hook. Then start the device flue, the lower part of the convergence of the five pipes, pay attention to the need to add a gasket, tighten. Connect the power supply and the indoor temperature controller. Open the front panel of the machine, according to N, L, E power supply, in accordance with the requirements of the temperature controller to connect the 1-3 contacts, and then installed on the shell.

4.注水检漏。注水与检漏是济南壁挂炉装置最重要的环节之一,翻开进水开关和注水开关,给采暖系统注水,将压力加至3,打开注水开关,看能否有漏点,并留意平安阀能否卸压。同时翻开卫浴间的热水龙头,看看能否有漏点。用肥皂水试一下燃气管路能否有燃气走漏。如无问题,翻开排水阀,将压力降到1即可完成。一切正常至此整个装置过程合理完成。Water leak detection. Water injection and leak detection is one of the most important part of Ji'nan boiler device, open water switch and switch to water, water heating system, the pressure is increased to 3, open water switch, to see whether there is leakage, and safety pressure relief valve can. At the same time, open the bathroom hot water, to see whether there is a leak. Use soap and water to try whether there is a gas leak gas pipeline. If no problem, open the drain valve, the pressure can be reduced to 1. All normal so that the whole process is completed.

关于济南壁挂炉的优势、壁挂炉装置办法的相关信息就为大家引见到这里了,希望这篇文章对大家有所帮助。Relevant information to advantage, bigualu device on the Ji'nan wall hanging stove is introduce to here, I hope this article to help you.

此站带排名出售
联系手机:15253134653
联系QQ号:347299818
联系微信:扫描下图二维码